MESA Series 100
Single Stage Cylinder Regulator

Standard Configuration

All regulators with the exception of the low inlet pressure series (see below) are sold complete with inlet CGA, two gauges and a diaphragm packless outlet control valve.Series 100  Regulator

Recommended Applications

The single stage cylinder regulator is recommended where slight changes in delivery pressure are acceptable as the cylinder pressure decreases. These regulators are ideally suited for periodic withdrawal of gas from pressurized cylinders.

Brass bodies are recommended for non-corrosive gases. Chrome plated brass bodies are also recommended for non-corrosive gases. The addition of chrome plating to the brass body helps to protect the outside body of the regulator from corrosive ambient conditions such as found in chemical plants and refineries. 316L Stainless Steel bodies are recommended for mildly corrosive gases. Monel and Hastelloy bodies are available upon special request.

Description

The MESA 100 Series regulators are precision manufactured from machined bar stock. This design minimizes contamination of the gas stream by in-board diffusion of atmospheric contaminates. The design also minimizes cross-contamination of the gas stream as is frequently encountered with less expensive forged body regulators.

Standard Materials of Construction


Body Options: 
     Brass 
     Chrome Plated Brass 
     316L Stainless Steel
Diaphragm: 
    
Teflon Lined 304 Stainless Steel
Seat:
    
Tefzel
Seals:
    
Teflon
Poppet:
     316L Stainless Steel
Poppet Spring: 
     Inconel 600
Inlet Filter: 
     20 Micron 316 Stainless Steel
Adjusting Knob: 
     Black Anodized Aluminum

Special Configuration for Low Inlet Pressure Applications

A specially deigned regulator is available for low inlet pressure applications such as encountered when sampling hydrocarbon mixes in low pressure cylinders. The regulator has a special seat designed to insure precise control of the delivery pressure at low inlet pressures. The regulator is sold complete with inlet CGA and two gauges. The standard diaphragm packless valve is replaced by a packed outlet control valve.

Available CGA: 110, 170, 180, 320, 326, 330, 346, 350, 510, 540, 580, 590, 660, 679 and 705


 

 Go to the top of the page

 

Company Information

ISO 9001:2000 Information

Typical Mixture Components

Cylinder Specifications

Product Specifications

Material Safety Data Sheets


 

MESA Specialty Gas-Company Information :: Petrochemical and Refinery Calibration Gas Standards :: Environmental and EPA Protocol Gas Standards ::
Health and Hygiene Calibration Gas Standards :: Instrument Grade Pure Gas ::
Specialty Gas regulators

 E-mail: mail@mesagas.com

Copyright 1993-2007 İMESA Specialty Gas -- All rights reserved.
MESA Specialty Gas & Equipment
Toll-Free: (866) 470-MESA (6372)
Tel: (714) 434-7102
Fax (714) 434-8006